VNSE quick start guide: Difference between revisions
(Created page with " == Introduction == VNSE is a virtual machine that contains a vSTREAM Agent and acts in the same way as a vSTREAM. == Solution == === Installation === ==== Deploy...") |
No edit summary |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
== Introduction == | == Introduction == | ||
VNSE is a virtual machine that contains a vSTREAM Agent and acts in the same way as a vSTREAM. | VNSE is a virtual machine that contains a (dormant) vSTREAM Agent and acts in the same way as a vSTREAM virtual appliance. VNSE can be deployed on ESXi 5.5 or higher. | ||
| | ||
== | == Installation == | ||
=== | === Step 1: download the archive === | ||
You should receive a download link from COMCERT. | |||
| |||
=== Step 2 : checksum the file === | |||
Computer the MD5 checksum and compare with the original value. DO NOT deploy the ovf if the values don't match. | |||
| |||
=== Step 3: deploy ovf === | |||
We assume you are familiar with deploying an ovf in vSphere Center. | |||
After deployment, the vm will have the following properties: | After deployment, the vm will have the following properties: | ||
| Line 26: | Line 36: | ||
The second NIC is used for <u>monitoring</u> and must be connected to a port group that allows monitoring of all VLAN on the hypervisior. For the moment, leave this interface assigned to "VM Network". | The second NIC is used for <u>monitoring</u> and must be connected to a port group that allows monitoring of all VLAN on the hypervisior. For the moment, leave this interface assigned to "VM Network". | ||
| |||
=== Step 4: start virtual machine === | |||
The COMCERT eningeer will take over from here. | |||
| | ||
Latest revision as of 17:47, 24 February 2020
Introduction
VNSE is a virtual machine that contains a (dormant) vSTREAM Agent and acts in the same way as a vSTREAM virtual appliance. VNSE can be deployed on ESXi 5.5 or higher.
Installation
Step 1: download the archive
You should receive a download link from COMCERT.
Step 2 : checksum the file
Computer the MD5 checksum and compare with the original value. DO NOT deploy the ovf if the values don't match.
Step 3: deploy ovf
We assume you are familiar with deploying an ovf in vSphere Center.
After deployment, the vm will have the following properties:
- 2 CPU
- 4GB RAM
- HD1 = 65GB
- HD2 = 235GB
- Two NIC
The first NIC is used for management and must be assigned to the corresponding port group in VMware. The COMCERT engineer will configure a static IP after deployment.
The second NIC is used for monitoring and must be connected to a port group that allows monitoring of all VLAN on the hypervisior. For the moment, leave this interface assigned to "VM Network".
Step 4: start virtual machine
The COMCERT eningeer will take over from here.