Configuring flow export: Difference between revisions
No edit summary |
No edit summary |
||
| Line 30: | Line 30: | ||
==== Sensor ==== | ==== Sensor ==== | ||
A | A ''sensor'' is a meter located at an observation point. It will "observe" the packets going by the observation point and "build" the flow record that decribes the flow. A sensor will observe and meter packets in one direction only (ingress/in or egress/out) or in both directions. Historically, a sensor was ingress/in only, so if left unspecified by a vendor, you may assume a sensor being ingress/in. | ||
Revision as of 17:47, 14 January 2018
Introduction
Correct configuration of Flow Exporting Devices (FED) is key to Flow Based Network Analysis. In most cases, errors made during configuration will result in missing or duplicate data. It may be difficult to spot that because of this the flow data is compromized. Device vendors are not making it easy and most of them use different methods to enable network flow exports to the collector (in our case TVF or TVA).
Furthermore, some collectors require a special setting on FED in order to undersand its flow records correctly.
This article is trying to decribe the idea behind network flow reporting and we hope it will help you to determine the correct procedure on how to confgure your FEDs.
For a complete overview of NetFlow or IPFIX, we recommend the reading of RFC 3917.
Solution
Definitions
FED
A Flow Enabled Device is any L3 and in some cases L2 device sending flow records to a collector.
Flow
A flow is defined as a stream of packets between a given source and a given destination. For example, in client-server computing a TCP sessions consists of two flows: one flow from client to server and the second flow from server to client.
Flow record
A flow record contains information about a specific flow that was metered at an observation point. A flow record contains measured properties of the flow (e.g., the total number of bytes of all packets of the flow, flow duration and the physical or virtual interface where the packets entered and exited the FED) and usually characteristic properties of the flow (e.g., source/destination IP address, protocol, port, ToS/DiffServ marking, ...).
Sensor
A sensor is a meter located at an observation point. It will "observe" the packets going by the observation point and "build" the flow record that decribes the flow. A sensor will observe and meter packets in one direction only (ingress/in or egress/out) or in both directions. Historically, a sensor was ingress/in only, so if left unspecified by a vendor, you may assume a sensor being ingress/in.