Configuring/resetting iDRAC: Difference between revisions

From wiki.comcert.com
Jump to navigation Jump to search
(Created page with "== Introduction == All Fluke Networks, Visual Networks, Netscout and COMCERT DELL bases appliances come with a iDRAC Management Interface with dedicated NIC. Its is high...")
 
No edit summary
Line 1: Line 1:
== Introduction ==
== Introduction ==


Line 13: Line 14:
 
 


=== Configuration via server's operating system ===
=== Configuration and reset via server's operating system ===


RACadmin is installed on all Fluke Networks, Visual Networks, Netscout and COMCERT DELL bases appliances. To use RACadmin, you must be root user.
RACadmin is installed on all Fluke Networks, Visual Networks, Netscout and COMCERT DELL bases appliances. To use RACadmin, you must be root user.

Revision as of 17:30, 3 March 2018

Introduction

All Fluke Networks, Visual Networks, Netscout and COMCERT DELL bases appliances come with a iDRAC Management Interface with dedicated NIC. Its is highly recommended to configure this interface appropriately to allow remote access to the appliance and to send system alerts to a network manegement station of your choice.

 

Solution

Configuration via system setup

iDRAC configuration is part of Setup.  Press <F2> during boot to enter the setup dialogue.

 

Configuration and reset via server's operating system

RACadmin is installed on all Fluke Networks, Visual Networks, Netscout and COMCERT DELL bases appliances. To use RACadmin, you must be root user.

Login to the CLI and if not already rioot, asume root priviledges:

$ sudo su -

To reset the iDRAC interface

# racadm

To view the iDRAC IP configuration

# racadm

To change the iDRAC IP address:

# racadm