NSE-X2 connections and environmental specifications: Difference between revisions

Revision as of 13:53, 11 August 2020

This picture shows the minimal set of ports that must be connected in order to operate normally.

Port 1: MANagement port: this port must be connected to a local switchport.

Port 2: not connected.

Port 3: MONitor port: this port must be connected to the SPAN representing the traffic FROM the network*.

Port 4: MONitor port: this port must be connected to the SPAN representing the traffic TO the network*.

Port 5: (SFP not present), not connected.

Port 6: (SFP not present), not connected.

(*) See configuration examples for Alcatel Lucent

(*) See configuration examples for Cisco

Width:

Hight:

Depth:

kg

PSU (Power): 2x 1100W (IEC320 C14 connector)

Maximum heat dissipation: 4100BTU/h

Frequency: 50Hz

Voltage: 240V AC

Maximum current: 6.5A

Power based on observation: 500W maximum, 350W average (both PSU powered)

@@ Line 1: / Line 1: @@
 [[File:WIP.jpg|center|150px|WIP.jpg]]
+=== Network connections (appliance rear view) ===
+This picture shows the minimal set of ports that must be connected in order to operate normally.
+Port 1: MANagement port: this port must be connected to a local switchport.
+Port 2: not connected.
+Port 3: MONitor port: this port must be connected to the SPAN representing the traffic FROM the network*.
+Port 4: MONitor port: this port must be connected to the SPAN representing the traffic TO the network*.
+Port 5: (SFP not present), not connected.
+Port 6: (SFP not present), not connected.
+(*) See configuration examples for Alcatel Lucent
+(*) See configuration examples for Cisco
+&nbsp;
+=== System dimensions ===
+Width:&nbsp;
+Hight:&nbsp;
+Depth:&nbsp;
+&nbsp;
+=== Weight ===
+kg
+&nbsp;
+=== PSU specifications ===
+PSU (Power): 2x 1100W (IEC320 C14 connector)
+Maximum heat dissipation: 4100BTU/h
+Frequency: 50Hz
+Voltage: 240V AC
+Maximum current: 6.5A
+Power based on observation: 500W maximum, 350W average (both PSU powered)
+&nbsp;
+&nbsp;