Transceiver Optical Interface Specifications: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 2: | Line 2: | ||
== Introduction == | == Introduction == | ||
These are common Optical Interface Specifications for the most common Network Standards. Some transceivers may perform better which will result in a higher loss tolerance and/or longer fiber runs. | These are the most common Optical Interface Specifications for the most common Network Standards. Some transceivers may perform better which will result in a higher loss tolerance and/or longer fiber runs. | ||
You may read these specifications as "worst case" values; under these circumstances the Network will work as specified by the Network Standard. | You may read these specifications as "worst case" values; under these circumstances the Network will work as specified by the Network Standard. | ||
| Line 29: | Line 29: | ||
! scope="col" | Optical interface | ! scope="col" | Optical interface | ||
! scope="col" | Standard | ! scope="col" | Standard | ||
! scope="col" | Wavelength | ! scope="col" | Wavelength (nm) | ||
! scope="col" | Receiver Saturation | ! scope="col" | Receiver Saturation (dBm) | ||
! scope="col" | Receiver Sensitivity | ! scope="col" | Receiver Sensitivity (dBm) | ||
! scope="col" | Maximum Distance rx/tx (km) | |||
|- | |- | ||
| | | 10GBASE-E | ||
| | | Single-mode | ||
| | | IEEE 802.3ae - 2002 | ||
| | | 1550 | ||
| | | -1.0 | ||
| | | -15.8 | ||
| | |||
|- | |||
| 10GBASE-ER | |||
| Single-mode | |||
| IEEE 802.3ae - 2002 | |||
| 1550 | |||
| -1.0 | |||
| -15.8 | |||
| | |||
|- | |- | ||
| 10GBASE-L | |||
| | | | ||
| | | | ||
| Line 45: | Line 56: | ||
| | | | ||
| | | | ||
| | | | ||
|} | |} | ||
| Line 51: | Line 62: | ||
=== === | === === | ||
| |||
| |||
| |||
| |||
Revision as of 09:47, 13 February 2021
Introduction
These are the most common Optical Interface Specifications for the most common Network Standards. Some transceivers may perform better which will result in a higher loss tolerance and/or longer fiber runs.
You may read these specifications as "worst case" values; under these circumstances the Network will work as specified by the Network Standard.
Solution
Safe Zone
Any optical tranceiver will operate when the power of the optical signal at the receiver is in the range between Receiver Sensitivity and Receiver Saturation.
Permanent Damage
Most receivers will be permanently damaged after exposure to an optical power of 5dBm.
10 Gigabit Optical Interface Specifications
| Optical interface | Standard | Wavelength (nm) | Receiver Saturation (dBm) | Receiver Sensitivity (dBm) | Maximum Distance rx/tx (km) | |
|---|---|---|---|---|---|---|
| 10GBASE-E | Single-mode | IEEE 802.3ae - 2002 | 1550 | -1.0 | -15.8 | |
| 10GBASE-ER | Single-mode | IEEE 802.3ae - 2002 | 1550 | -1.0 | -15.8 | |
| 10GBASE-L |