Transceiver Optical Interface Specifications: Difference between revisions
No edit summary |
No edit summary |
||
Line 88: | Line 88: | ||
| | ||
=== === | |||
=== === | |||
=== === | |||
=== === | |||
=== === | |||
=== === | |||
=== === | |||
=== 40 Gigabit Optical Interface Specifications === | === 40 Gigabit Optical Interface Specifications === | ||
Line 100: | Line 114: | ||
! scope="col" | Receiver Sensitivity (dBm) | ! scope="col" | Receiver Sensitivity (dBm) | ||
! scope="col" | Maximum Distance rx--tx | ! scope="col" | Maximum Distance rx--tx | ||
|} | |} |
Revision as of 10:24, 13 February 2021
Introduction
These are Tranceiver Optical Interface Specifications for the most common Network Standards. ANY optical tranceiver that lists itself as compliant with the standard, MUST be able to operate correctly when the power of the optical signal at the receiver is in the range between Receiver Sensitivity and Receiver Saturation. Transceivers by some vendors may perform better; resulting in higher limits for loss and length when using them on both ends of the link.
You may read these specifications as "worst case" values; under these circumstances the Network will work as specified by the Network Standard.
These tabels will grow as we come accross the specification for other interface specifications.
Solution
Always be very careful when operating optical networks. Infra-red radiation is invisible to the naked eye. |
Permanent Damage
Receivers will be permanently damaged after exposure to an optical power of 5dBm or more. This is OK, as Average Launch Powers is not higher than +4.0dBm.
10 Gigabit Optical Interface Specifications
Optical interface | Standard | Wavelength (nm) | Receiver Saturation (dBm) | Receiver Sensitivity (dBm) | Maximum Distance rx--tx | |
---|---|---|---|---|---|---|
10GBASE-E and -ER | Single-mode | IEEE 802.3ae - 2002 | 1550 | -1.0 | -15.8 | 40km |
10GBASE-L and -LR | Single-mode | IEEE 802.3ae - 2002 | 1310 | +0.5 | -14.4 | 10km |
10GBASE-LRM | Multi-mode | IEEE 802.3aq - 2006 | 1300 | +1.5 | -6.5 |
OM3: OM4/OM5: |
10GBASE-S and -SR | Multi-mode | IEEE 802.3ae - 2002 | 850 | -1.0 | -9.9 |
OM3: OM4/OM5: |
10GBASE-Z and -ZR | Single-mode | Multivendor agreement | 1550 | -7.0 | -24.0 | 80km |
40 Gigabit Optical Interface Specifications
Optical interface | Standard | Wavelength (nm) | Receiver Saturation (dBm) | Receiver Sensitivity (dBm) | Maximum Distance rx--tx |
---|