Transceiver Optical Interface Specifications

From wiki.comcert.com
Revision as of 09:47, 13 February 2021 by Bert (talk | contribs)
Jump to navigation Jump to search

Introduction

These are the most common Optical Interface Specifications for the most common Network Standards.  Some transceivers may perform better which will result in a higher loss tolerance and/or longer fiber runs.

You may read these specifications as "worst case" values; under these circumstances the Network will work as specified by the Network Standard.

 

Solution

Safe Zone

Any optical tranceiver will operate when the power of the optical signal at the receiver is in the range between Receiver Sensitivity and Receiver Saturation.

 

Permanent Damage

Most receivers will be permanently damaged after exposure to an optical power of 5dBm.

 

10 Gigabit Optical Interface Specifications

  Optical interface Standard Wavelength (nm) Receiver Saturation (dBm) Receiver Sensitivity (dBm) Maximum Distance rx/tx (km)
10GBASE-E Single-mode IEEE 802.3ae - 2002 1550 -1.0 -15.8
10GBASE-ER Single-mode IEEE 802.3ae - 2002 1550 -1.0 -15.8
10GBASE-L