VNSE quick start guide

Introduction

VNSE is a virtual machine that contains a vSTREAM Agent and acts in the same way as a vSTREAM.  VNSE can be deployed on ESXi 5.5 or higher.

 

Installation

Step 1: download the archive

You should receive a download link from COMCERT.

 

Step 2 : checksum the file

Computer the MD5 checksum and compare with the original value.  DO NOT deploy the ovf if the values don't match.

 

Step 3: deploy ovf

We assume you are familiar with deploying an ovf in vSphere Center.

After deployment, the vm will have the following properties:

• 2 CPU
• 4GB RAM
• HD1 = 65GB
• HD2 = 235GB
• Two NIC

The first NIC is used for management and must be assigned to the corresponding port group in VMware.  The COMCERT engineer will configure a static IP after deployment.

The second NIC is used for monitoring and must be connected to a port group that allows monitoring of all VLAN on the hypervisior.  For the moment, leave this interface assigned to "VM Network".

 

Step 4: start virtual machine

The COMCERT eningeer will take over from here.