PMA-2XX Physical installation connections and environmental specifications
Network connections (appliance rear view)
This picture shows the minimal set of ports that must be connected.
Located on the appliance's motherboard:
Ports for management interface and virtual console (iDRAC): 1000BASE-T
Management interface (MGT): 2x 1000BASE-T and 2x 10GBASE-T. At least one of these ports must be connected to the network. This picture show a connection to the third port from the left.
Located on the NETSCOUT ASI Accelerator NIC:
Monitor (MON): 4x SFP+. These slots are empty and must be equipped with compatible fiber optic transceivers. Attention: copper transceivers are not supported. At least one of these ports must be connected to a SPAN or TAP output. Ports are numbered from right to left, starting with names if3, if4, if5 and if6.
System dimensions
Width: 430.0mm (19 inch)
Hight: 86.8mm (2U)
Depth: 715.5mm
Weight (without rails)
33.1kg
Weight (including sliding rails and cable management)
36kg
PSU specifications
PSU (Power): 2x 1100W (IEC320 C14 connector)
Maximum heat dissipation: 4100BTU/h
Frequency: 50Hz
Voltage: 240V AC
Maximum current: 6.5A
Measured power consumption: 500W maximum, 350W average (both PSU cabled and active)