PMA-2XX Physical installation connections and environmental specifications
Network connections (appliance rear view)
This picture shows the minimal set of ports to be connected to operate.
For other configurations, please contact COMCERT support.
Located on the appliance's motherboard:
Ports for management interface and virtual console (iDRAC): 1000BASE-T
Management interface (MGT): 2x 1000BASE-T and 2x 10GBASE-T. At least one of these ports must be connected to the network. This picture show a connection to the third port from the left.
Located on the NETSCOUT ASI Accelerator NIC:
Monitor (MON): 4x SFP+. These slots are empty and must be equipped with compatible fiber optic transceivers. Attention: copper transceivers are not supported. At least one of these ports must be connected to a SPAN or TAP output. Ports are numbered from right to left, starting with names if3, if4, if5 and if6.
System dimensions
Width: 430.0mm (19 inch)
Hight: 86.8mm (2U)
Depth: 715.5mm
Weight
Without rails 33.1kg
Including sliding rails and cable management 36.0kg
Power and heat
PSU (Power): 2x 1100W (IEC320 C14 connector)
Maximum heat dissipation: 4100BTU/h
Frequency: 50Hz
Voltage: 240V AC
Maximum current: 6.5A
Measured power consumption: 500W maximum, 350W average (both PSU cabled and active)