PMA-2XX Physical installation connections and environmental specifications
Network connections (appliance rear view)
This picture shows a minimal set of ports to be connected in order to operate.
For other configurations, please contact COMCERT support.
Located on the appliance's motherboard:
Ports for management interface and virtual console (iDRAC): This is a 1000BASE-T Ethernet interface.
Management interface (MGT) (left to right): 2x 10GBASE-T and 2x 1000BASE-T. At least one of these ports must be connected to the network. This picture show a connection to the third port from the left. This is a 1000BASE-T Ethernet interface.
Located on the NETSCOUT ASI Accelerator NIC:
Monitor (MON): 4x SFP+. These slots are empty and must be equipped with compatible fiber optic transceivers. Attention: copper transceivers are not supported. At least one of these ports must be connected to a SPAN or TAP output. Ports are numbered (right to left) if3, if4, if5 and if6.
Dimensions
Width: 430.0mm (19 inch)
Hight: 86.8mm (2U)
Depth: 715.5mm
Weight
Without rails 33.1kg
Including sliding rails and cable management 36.0kg
Power and heat
PSU (Power): 2x 1100W (ISO/IEC320 C14 connector)
Maximum heat dissipation: 4100BTU/h
Frequency: 50Hz
Voltage: 240V AC
Maximum current: 6.5A
Measured power consumption: 500W maximum, 350W average (both PSU cabled and active)
Accessories
- 2x ISO/IEC320 C13/C14 cables 2m
- 2x ISO/IEC320 C13/C14 cables 5m
- 1x pair of sliding rails
- 1x cable management arm
In accordance with COMCERT's policy for sustainability, unwanted accessories are preferably recuperated for reuse.