PMA-2XX Physical installation connections and environmental specifications
Jump to navigation
Jump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
Network connections (appliance rear view)
This picture assumes the PMA isbeing used as a NETSCOUT InfiniStream Appliance. It shows a minimal set of ports to be connected in order to operate fully.
For other configuration options, please contact COMCERT support.
Located on the appliance motherboard:
- Management interfaces (MGT) from left to right: 10GBASE-T, 10GBASE-T, 1000BASE-T and 1000BASE-T. One of these ports must be connected to the network. By default, the third port from the left is used as the appliance management interface.
- Dedicated virtual console interface (iDRAC). This is a 1000BASE-T Ethernet interface.
Located on the NETSCOUT ASI Accelerator NIC:
- Monitor interfaces (MON): 4x SFP+ slots. These slots are empty and are to be equipped with compatible fiber optic transceivers. Attention: copper transceivers are not supported. At least one of these ports must be connected to a SPAN or TAP output. These ports are named (from right to left) if3, if4, if5 and if6.
Dimensions
- Width: 430.0mm (19 inch)
- Hight: 86.8mm (2U)
- Depth: 715.5mm
Weight
- Without rails 29kg
- Including sliding rails and cable management 32kg
Power and heat
- PSU (Power): 2x 1100W (ISO/IEC320 C14 connector)
- Maximum heat dissipation: 4100BTU/h
- Frequency: 50Hz
- Voltage: 240V AC
- Maximum current: 6.5A
- Measured power consumption: 500W maximum, 350W average (both PSU cabled and active)
Accessories
- 2x ISO/IEC320 C13/C14 cable
- 1x pair of sliding rails
- 1x cable management arm
In accordance with COMCERT Durability Procedures, unwanted accessories may be returned to COMCERT for re-use.