PMA-XX Environmental specifications: Difference between revisions

From wiki.comcert.com
Jump to navigation Jump to search
No edit summary
No edit summary
Line 2: Line 2:
=== Network connections (appliance rear view) ===
=== Network connections (appliance rear view) ===


This picture shows the minimal set of ports that must be connected.
This picture shows the connection on the rear of the appliance.


 
 
Line 10: Line 10:
 
 


==== Located on the server base: ====
==== IP remote management interface (iDRAC): 1x 1000BASE-T ====


IP management interface ('''iDRAC'''): 1x 1000BASE-T
Management ports (MGT1 & MGT2): 2x 1000BASE-T


Management port (MGT): 2x 1000BASE-T
These two management ports for a team that form a redundant uplink to the network


Optional monitor port (MON): 2x 1000BASE-T 
Optional monitor port (MON1 & MON2): 2x 1000BASE-T
 
These ports  


 
 

Revision as of 12:46, 28 May 2020

Network connections (appliance rear view)

This picture shows the connection on the rear of the appliance.

 

PMAXXREARConnections.png
PMAXXREARConnections.png

 

IP remote management interface (iDRAC): 1x 1000BASE-T

Management ports (MGT1 & MGT2): 2x 1000BASE-T

These two management ports for a team that form a redundant uplink to the network

Optional monitor port (MON1 & MON2): 2x 1000BASE-T

These ports  

 

System dimensions

Width: 430.0mm (19 inch)

Hight: 86.8mm (2U)

Depth: 715.5mm

 

Weight

33.1kg

 

PSU specifications

PSU (Power): 2x 1100W (IEC320 C14 connector)

Maximum heat dissipation: 4100BTU/h

Frequency: 50Hz

Voltage: 240V AC

Maximum current: 6.5A

Power based on observation: 500W maximum, 350W average (both PSU powered)

 

Network connections

Located on the server's motherboard:

Out-of-band management and virtual console (iDRAC): 1x 1000BASE-T

Management (MGT): 2x 1000BASE-T and 2x 10GBASE-T. At least one of these ports must be connected to a switch port.

Located on the ASI Accelerator NIC:

Monitor (MON): 4x SFP+. These slots are empty and must be equipped with fiber optic transceivers. Copper transceivers are not supported. One or more of these ports must be connected to a SPAN or TAP.  Ports are numbered from right to left, starting at number 3 then 4, 5 and 6.