PMA-2XX quick start guide
Introduction
COMCERT PMA-2XX is a custom-build appliance, optimized for running NETSCOUT nGENIUS InfiniStream. This guide will assist you in configuring the appliance for first use.
Solution
Physical installation and connections
Please visit PMA-2XX Physical installation, connections and environmental specifications for detailed information on how to install the appliance and connect it to the network.
IP configuration
The appliance management (MGT) and out-of-band (iDRAC) interface comes pre configured with the following IP settings.
| Parameter | MGT (IP_PMA) | iDAC (IP_IDRAC) |
|---|---|---|
| IP address | 192.168.0.1 | 192.168.1.1 |
| IP subnet mask | 255.255.255.0 | 255.255.255.0 |
| Default router | 192.168.0.1 | 192.168.1.1 |
| DNS Server | 192.168.0.1 | 192.168.1.1 |
| Domain suffix | comcert.com | comcert.com |
| NTP Server | 192.168.0.1 | 192.168.1.1 |
To access the appliance either by its management interface or out-of-band interface, use a computer with a static IP address in the same IP subnet as the respective interface and a standard four-pair twisted-pair cable. The management interface is only accessible using the ssh protocol. The out-of-band interface is accessible by either https (preference) or ssh. For default credentials please visit Default credentials . Please make sure to change these default passwords and store them is a sale place.
Changing the IP configuration
Out-of-band (iDRAC)
The IP configuration of the out-of-band interface can be changed via the WebUI or during the appliance boot process using a KVM. During boot, press <F2> to enter the setup menu and select iDRAC. Make sure to save the new settings.
PMA-2XX (MGT)
Do not change the IP configuration by editing the Linux configuration files.
As we mentionned in the introduction, the main purpose of the PMA-2XX is to serve as an appliance for NETSCOUT nGENIUS InfiniStream. The generic name for InfiniStream is nGENIUS Agent. Changing the IP address of the PMA-2XX must be done in accordance to NETSCOUT instructions.
Access the appliance as root using an up-to-date ssh client of your choise. For default credentials please visit Default credentials .
- Execute the follwing commands to stop all services:
# isbin # ./stopall
- Execute the follwing commands to check for running services:
# ./PS
- Execute the follwing commands to run the configuration dialog:
# ./nGAppliance
In case you make a mistake, Ctrl-C out of the dialog and re-run the configuration dialog (third step).
At the end of the process, you wil need to reboot the appliance.
Next steps
Now that the IP addresses are changed, the appliance should be accessible across the local network. InfiniStream must now be connected to the nGeniusONE Server. Intructions on how to do that can be found in the nGenius Agent Administration Guide that can be found on the MyNetscout portal.