PMA-2XX quick start guide
Introduction
COMCERT PMA-2XX is a custom-build appliance optimized for running NETSCOUT InfiniStream. This guide will assist you in configuring the appliance for first use.
Solution
Physical installation and connections
Please visit PMA-2XX Physical installation, connections and environmental specifications for detailed information on how to install the appliance and connect it to the network.
IP configuration
The appliance management (MGT) and out-of-band (iDRAC) interface comes pre configured with the following IP settings.
| Parameter | MGT (IP_PMA) | iDAC (IP_IDRAC) |
|---|---|---|
| IP address | 192.168.0.1 | 192.168.1.1 |
| IP subnet mask | 255.255.255.0 | 255.255.255.0 |
| Default router | 192.168.0.1 | 192.168.1.1 |
| DNS Server | 192.168.0.1 | 192.168.1.1 |
| Domain suffix | comcert.com | comcert.com |
| NTP Server | 192.168.0.1 | 192.168.1.1 |
To access the appliance either by its management interface or out-of-band interface, use a computer with a static IP address in the same IP subnet as the respective interface and a standard four-pair twisted-pair cable. The management interface is only accessible using the ssh protocol. The out-of-band interface is accessible by either https (preference) or ssh. For default credentials please visit Default credentials . Please make sure to change these default passwords and store them is a sale place.
Changing the IP configuration
Out-of-band (iDRAC)
The IP configuration of the out-of-band interface can be changed via the WebUI or during the appliance boot process using a KVM. During boot, press <F2> to enter the setup menu and select iDRAC. Make sure to save the new settings.
PMA-2XX (MGT)
As we mentionned in the introduction, the main purpose of the PMA-2XX is to serve as an appliance for NETSCOUT InfiniStream. Changing the IP address of the PMA-2XX is done in accordance to NETSCOUT instructions.
Access the appliance as root using an up-to-date ssh client of your choise. For default credentials please visit Default credentials .
Execute the follwing commands:
- isbin
- ./nGAppliance
This will open a dialog that allows you to modify its existing IP configuration. If you make a mistake, Ctrl-C out of the dialog and start over.